2011-093 Ordinance - Laserfiche WebLink

Home Browse Search

1369.06 SPECIFICATIONS FOR CHAIN LINK FENCES. The following specifications, derived from ASTM F567, and Standard Practice in the Fence Industry, shall apply to the materials and construction of chain link fences: (a) Structural Members: (1) Posts. Post spacing shall not exceed ten feet (10'). Posts shall be set in concrete. Diameter of holes shall be four times the largest cross section of the post. (2) D~th. Depth shall be a minimum of twenty-four inches (24") for afour- foot high fence, plus an additional three inches (3 ") for each additional one foot increase in height over four feet. (3) Top rail. Atop rail shall be used for all chain link fences. Top rail shall be continuous between terminals and shall be swedged or sleeved. Top rail shall be supported at all posts. At corners and terminals, rail shall be connected by means of a rail end fitting. (4) Dimensions of structural members Member Top Rail Line Post Terminal and Gate Post Minimum Diameter 5 ft or less in height Greater than 5 ft 1-3/8 in. 1-3/8 in. 1-5/8 in. 2-1/2 in. 2 in. 2-1/2 in. (5) Fabric. The selvage edge of wire fabric shall be knuckled top and bottom. The fabric shall be installed with only a knuckled edge at the top and bottom. Rolls of wire fabric shall be joined by weaving a single picket into the ends of rolls to form a continuous mesh. Fasten fabric to line posts at intervals not exceeding fifteen inches (15"). Fasten fabric to top rail at intervals not exceeding twenty-four inches (24"). Tension bars shall be used at all terminal, corner and gate posts. Fabric shall be tightened to provide a smooth, uniform appearance free from sag. For residential applications, minimum gauge of chain link fence fabric shall be 11'/2 gauge. For non residential applications, minimum gauge of chain link fence fabric shall be 9 gauge.