2024-028 Ordinance - Laserfiche WebLink

Home Browse Search

(1) The plat shall be drawn on linen cloth or equal material with India ink to the scale of one inch equals fifty feet. Scale may be waived by the City Engineer. The linen shall not be smaller than one foot by two feet or larger than two feet by three feet. Large plats may require more than one sheet. If so, the sheets shall be numbered consecutively and indexed. (2) Dimensions shall be expressed in feet and decimal parts thereof to the nearest hundredth of a foot. Angles shall be expressed in degrees, minutes and seconds to the nearest second. (3) The plat shall be complete and consistent in itself as to all measurements. Bearings shall be assumed to show angles. (4) The plat shall show north arrow, date, names and addresses of owners, surveyors and developer. (5) The plat shall show an acceptance and dedication clause and approvals by City officials, which acceptance and dedication shall be for record purposes only unless the developer submits, and Council accepts, a petition described in Section 1101.11. Approval clauses for Director of taw, City Engineer, Director of Public Service, Planning and Design Commission and Council shall be provided on the plat. (6) Monuments shall be indicated on the plat at all angles in the boundary of the subdivision and at all intersections of streets within the subdivision; at all points of curvature, points of tangency, points of intersection and corporation lines for street centerlines within the subdivision. These monuments shall be set in the field at all points indicated on the subdivision plat before the plat is approved for records purposes except monuments in areas to be paved. Monuments in areas to be paved shall be set during or immediately after the pavement is constructed. Municipal, Township, section lines, original lot lines and other survey control lines shall be accurately tied to lines of subdivision. (7) Streets in the subdivision shall be given names different from existing street names within the City, and shall be checked with the North Olmsted Post Office to prevent area duplication of names. (8) Building setback lines shall be shown on the plat. (9) Property adjacent to the subdivision shall show the owner's name and either the volume and page of his deed or the County Auditor's Permanent Parcel Number. (10) Existing streets terminating near the subdivision boundary shall be shown. (11) Easements for utilities and drainage shall be shown naming the utilities. The City Engineer shall approve the width and location of the easements. (12) Streets: _ A. Minimum right-of-way width shall be sixty feet, whether streets are intersection streets or periphery streets abutting lands adjacent to the area to be subdivided. B. No reserve strips abutting streets are permitted. C. Location of streets shall conform with the City's General Plan. Turnout radius at the intersection of right-of-way lines shall be a minimum of thirty feet. D. Street intersections shall be at ninety degrees where practicable, however, never less than sixty degrees. The maximum length of a street between intersections shall be 1,300 feet. No street centerline