53-10 Amend Chapter 1329, Signs - Laserfiche WebLink

Home Browse Search

Proposed Ordinance 53-10. Substituted October 18, 2010. (12) Window signs. All window signage including business identification, merchandise signs, temporary signs shall be equal to or less than 15% of the total storefront window area square footage. (d) Subolementary Area and Location Standards. (e) (1) Side and rear entrances. In cases where the office or business building has an entrance from the side street of a corner lot or has a back entrance from a parking lot open to the public, additional sign area equal to twenty-five percent (25%) of that permitted on the front. of the building may be used over such entrance. (Ord. 52-85. Passed 9-3-85.) (2) Shoppina center identification signs. In addition to the sign face area permitted for each individual establishment, one shopping center sign identifying the name and/or logo of a unified shopping area in the C1, C2, C3 Districts may be permitted, subject to review and approval by the Board of Building Standards. Shopping center signs shall not exceed forty square feet in area and may be a ground sign, subject to the regulations governing such sign. (Ord. 25-95. Passed 10-7-96.) (4) Vacant lots. Each vacant lot is permitted a maximum sign area of fifty square feet, limited to a ground sign which shall be located no closer to any street than the required building setback line. (5) One sign per building face. Notwithstanding the provision of this section, each business shall be permitted a maximum of one sign on any single building face for the building, or the portion of the building, in which the business is located; provided that this limitation shall not apply to directional signs, nameplates or real estate signs, or to a second noncommercial sign which shall not exceed five square feet. (Ord. 52-85. Passed 9-3-85.) Air-Objects, Off-Premises and Wind Signs. Portable signs roof signs, billboards, pole signs, streamers, pennants, lighter-than-air objects, off-premises and wind signs, shall not be permitted in the Cl, C2, C3 zoning districts unless permitted by specific provisions of this chapter (f) Regulations for Billboards Existing Billboards may be retained, but only the sign area may be modified. Any change to the structure, frame or support are not permitted. If such a change is necessary, the billboard must be removed and cannot be replaced. 1329.10 SIGNS: INDUSTRIAL I DISTRICT. Accessory signs in the Industrial I District shall be designed, erected, altered, moved and maintained in whole or in part, in accordance with these regulations. The requirements of the Industrial District shall be the same as the requirements of the Cl, C2 and C3 Districts specified in Section 1329.09, except as otherwise stated herein. Page 26 of 28