2001-096 Resolution - Laserfiche WebLink

Home Browse Search

Specifications CAB The cab shall be designed specifically for the fire service and manufactured by the chassis builder. Consti-uction of the cab shall consist of 5052-.125" aluminum welded to extruded aluminum framing. The cab shall be built bv the apparatus inanufacturer in a facility located on the manufacturer's premises. (no exceptions) The cab shall be 96.00" wide, with an interior width of 87.50". The forvvard cab section overall height (cab roof to ground) shall be approximately 99.00". The crew cab section shall have a 10.00" raised roof with an overall cab heiaht of 109". The floor to ceilinL, height inside the crew cab sha11 be 62.50. The crew cab floor shall measure 4' ).75" from rear wall to the back side of enyine tunnel. The crew cab shall be of the totally enclosed desian, with access doors constructed in the same manner as the driver and passen1ger doors. The cab shall be a full tilt cab style. The enaine shall be easily accessible and capable of beina removed xith the cab tilted. The cab shall have three (3)-point rubber mountina and shall be tilted by a hydraulic pump connected to two (2) cab lift cylinders. The cab shall then be locl.ed down by a two (2 )-point automatic loclcing mechanism that actuates after the cab has been lowered. The cab access steps sha11 be 22.00" wide, crew eab shall be 21,50" wide x 8.00" minimuin depth, located inside the door, protecting the step from weather elements. The inside cab steps shall not exceed 16.50" high. -Tbe crew cab entrance shall be a two (2) step desiQn for easy access. A 20.00", slip resistant, handrail shall be provided adjacent to all door openiilgs to assist entrance into the cab. A rubber covered handrail shall be pro?,,ided inside each front cab door, adjacent to the door posts. The cab doors sha11 be 35.00" wide x 69.00" high. Bidder Complies Yes I No Pa¢e 18