Laserfiche WebLink
Specirications <br />(5) All lights that have their sockets in a weather exposed area shall have coirosion <br />prevenfative compound added to the socket terminal area. <br />(6) All electrical terminals in exposed areas shall have silicon (1890) applied completely over <br />the metal portion of the terminaL Identification of the switches shall be done by either- <br />pl-intinE or etchinQ on the switch paneL The switches and identification shall be illuminated. <br />All lights and reflectors, required to comply with Federai Motor Vehicle Safety Standard <br />#108, shall be furnished. Rear identif cation lights shall be recessed mounted for protection. <br />Li-hts and wiring inounted in the rear bulkheads shall be protected from dama-e by installing <br />a false bulkhead inside the rear compartments. <br />An operational tesf shall be conducted to ensure that any equipznent that is permanentlN? <br />attached to the electrical system is properlv conilected and in working order. <br />Tne results of the tests shall be recorded and pi•ovided to the purchaser at time of deliven,7. <br />S'I'EP LIGHTS <br />Four (4) Weldozi. Mode1 9186-23882-30, step ligllts shall be provided. <br />One (1) step light shall be provided oi1 each side, an the front compartment face. <br />Two (2) step Iights at rear; shall illuminate the tailboard. <br />These step Iights shall be actuated with the pump panel Iight switch. <br />REAR FMVSS LIGHTING <br />The rear stop/tail/duectional 1ights shall be Truck-Lite 4.00" round, 11-ht emittinc, diode <br />(LED) lamp lcits. Each lamp liit shall include a lamp, a rubber groinmet and a connector p1uQ. <br />The following light kits shall be provided: <br />Two (2) Truck-Lite, Model 44002R, red stop/tail light assemblies. <br />Two (?) Truck-Lite, Model 44001Y, amber directional liaht assemblies. <br />The lights shall be mounted on the rear face of the rear fender compartment by the use of the <br />1-ubber Lrommet. <br />Four (4) red reflectors shall be provided. <br />A Weldon, Model 23882-2600-00; license plate bracket shall be mounted on the driver's side <br />above the warning lights. A Weldon; Model 9186-23882-30, step lamp shall illununate the <br />license plate. <br />Bidder <br />Compiies <br />Yes I No <br />PaRe 60