Laserfiche WebLink
Specifications <br />110 VOLT INTERIOR RECEPTACLE <br />Receptacle shall be a NEMA 5-15, 110 volt, <br />connected to the shoreline. <br />Tliere shall be two (2) receptacles provided. <br />15 amp, three (3) wire duplex household type <br />Locations one each in the front and rear of the cab to match job #711937. <br />120 VOLT EXTERIOR RECEPT'ACLE <br />Receptacle shall be a Woodhead, NEMA 5-20, 120 volt, 20 amp, three (3) wire duplex <br />household type with a weather resistant cover connector to the 2enerator. <br />There shall be two (2) receptacles provided. <br />Located one on each pump panel. <br />LOOSE EQUIPMENT <br />The following equipment shall be funZished with the completed unit: <br />- One (1) bag of chronle, stainless steel, or cadmium plated screws, nuts, bolts and washers, as <br />used in the construction of the unit <br />PAI'_\ T <br />The exterior custom cab and bod?r painting procedure shall consist of a six (6) step finishing <br />process as follows: ` <br />1. Manual Surface Pre arp ation - All eaposed metal surfaces on the custom cab and bodv shall <br />be thorouQhly cleaned and prepared for painting. Suriaces that shall not be painted include al1 <br />chrome plated, poIished stainless steel, anodized aluminunl and bright aluminum treadplate. <br />Each imperfection oi7 the exterior metal surface shall be removed or filled and then sanded <br />smooth for a smooth appearance. All seains sha11 be sealed before painting. <br />2. Chemical Cleaning and Treatment - The meta1 surfaces shall be properly cleaned usina a <br />hiah pressure and high temperature acid etching system. Surfaces are chemically cleaned to <br />renlove all dirt, oil, grease and metal oxides to ensure the subsequent coatings bond well. Aiz <br />ultra pure water final rinse sha11 be applied to a11 metal surfaces, excluding undercazz-iaQe <br />components, at the conclusion of the metal treatment process. <br />3. Primer/Surfacer Coats - A two (2) component urethane primer%surtacer shali be hand <br />applied to the chemically treated metal surfaces to provide a strong corrosion protective base <br />coat and to smooth out the surface. <br />4. Hand Sanding - The primerisurfacer coat shall be lightly sanded to an ultra smooth finisli. <br />?. Sealer Primer Coat - A two (2) component sealer primer coat shall be applied over the <br />sanded primer. <br />Page 72 <br />Bidder <br />Complies <br />f I'es I No I