Laserfiche WebLink
Over 1/2 inch to 1 inch 1/2 inch Equal to width <br />Over 1 inch to 2 inch 1/2 inch 1/2 of width <br />3.03 APPLICATION <br />A. Exercise care before, during, and after installation so as not to damage any material by <br />tearing or puncturing. All finished work shall be approved before covering with any other <br />material or construction. <br />B. Apply sealant by an approved type of gun except where the use of a gun is not practicable, <br />suitable hand tools shall be used. Avoid applying the compound to any surface outside of <br />the joints or spaces to be sealed. Mask areas where required to prevent overlapping of <br />sealant. <br />C. All joints shall be waterproof and weathertight. <br />D. Point sealed joints to make a slightly concave joint, the edges of which are flush with the <br />surrounding surfaces. Exposed joints in the interior side of the door and other frames shall <br />be neatly pointed flush or to match adjacent jointing work. <br />E. Adjacent materials which have been soiled shall be cleaned immediately and the work left in <br />neat and clean condition. <br />F. Comply with sealant manufacturer's written instructions except where more stringent <br />requirements are shown or specified and except where manufacturer's technical <br />representative directs otherwise. <br />3.04 ADJUSTMENT AND CLEANING <br />A. Remove misplaced sealant compounds promptly using methods and materials <br />recommended by the manufacturer, as the work progresses. <br />B. Allow sealants to cure and remove protective edging, of doors, louvers, saddles windows etc. <br />as directed by the Engineer. <br />3.05 SCHEDULE <br />Application <br />Schedule of Sealants <br />Sealant Color <br />Vertical and horizontal joints bordered on both Type 2 <br />sides by concrete, masonry, precast concrete, <br />natural stone or other porous building material. <br />Vertical and horizontal joints bordered on both Type 3 <br />sides by painted metals, anodized aluminum, <br />mill finished aluminum, PVC, glass or other <br />non - porous building material. <br />Masonry expansion and control joints less than Type 2 <br />11/4" wide. <br />Masonry expansion and control joints equal or Type 1 <br />greater than 1 1/a inches wide and not to exceed <br />30048 -005: 812312012 07900 -4 <br />To closely match adjacent <br />surfaces or mortar and as <br />selected by the Owner. <br />To closely match adjacent <br />surfaces and as selected <br />by the Owner. <br />To closely match adjacent <br />surfaces and as selected <br />by the Owner. <br />To closely match adjacent <br />surfaces and as selected <br />North Olmsted Phase 2 <br />