84-125 Ordinance - Laserfiche WebLink

Home Browse Search

CITY OF NORTH OLMSTED ORDINANCE N0. 84- 125 PAGE 2 structures on the parcel to be subdivided; the existing structures on properties immediately adjacent and within twenty feet (20') of the boundary line; and the location and description of plugged, capped or active gas wells, within the subdivision and within one hundred feet (100') of the boundaries of the proposed subdivision. (4) The location map shall show the location of all peripheral streets and subdivisions within approximately one (1) mile of the land to be developed and showing the proposed subdivision and proposed streets shall be drawn on the preliminary plan or the proposed subdivision shall be drawn on a copy of the City Zone Map and submitted along with the preliminary plan. (5) The City shall be provided with twelve (12) copies of the Preliminary Plan and one (1) copy of the Location Map. The North Olmsted Board of Education shall be provided with one (1) copy of the Preliminary Plan. (c) A topographic map shall be prepared by a professional Land Surveyor registered in Ohio. Said topographic map shall contain the following: (1) It shall be accurately drawn to a scale of one inch (1") equals fifty feet (501) with a contour interval of one foot (1') unless waived by the City Engineer. The elevations shall conform to sea level elevations established by the Cleveland Regional Geodetic Survey. The Geodetic Bench mark used shall be indicated thereon. (2) The topographic map shall show the location of houses on the lots, finished ground elevation at the house and lot corners, existing improvements on adjoining streets and proposed block and lot drainage. (3) The City of North Olmsted shall be provided with at least three (3) copies of the topographic nap, and one (1) reproducible mylar transparency. (d) The plat shall be prePared by a professional Land Surveyor registered in Ohio and his signature, registration number and seal shall appear thereon. Said plat shall contain the following information; (1) The plat shall be drawn on linen cloth or equal material with India ink to the scale one inch (1") equals fifty feet (50'). Scale may be waived by the City Engineer. The linen shall not be smaller than one feet (1') by two feet (2') or larger than two feet (2') by three feet (3'). Large plats may require more than one sheet. If so, the sheets shall be numbered consecutively and indexed. (2) Dimensions shall be expressed in feet and decimal parts thereof to the nearest hundredth of a foot. Angles shall be expressed in degrees, minutes and seconds to the nearest second. (3) The plat shall be complete and consistent in itself as to all measurements. Bearings shall be assumed to show angles. (4) The plat shall show north arrow, date, name and address of owners, surveyor and developer. (5) The plat shall show acceptance and dedication clause and