2001-096 Resolution - Laserfiche WebLink

Home Browse Search

Speciflcations for it shall be located at the front of the tray for ease of use with a aloved hand. Tray location shall be per NOFD. Heavy-duty steel angle iron assembly shall support the body under the compartment floor. It shall be attached to the chassis frame for load transfer and to reduce stress on bodv. ADJUSTABLESHELVES There shall be ten (10) shelves, with a minimum capacit-y of 215 pounds provided. The shelf construction shall cansist of.125' pan-shaped aluminum with 2.00" sides. Each shelf shall be infinitely adjustable by means of a threaded fastener, which slides in a track. The location of the shelfi'shelves shall be per NOFD instructions at pre-build. MOUNTING TRACKS There shall be seven (7) sets of tracks for mounting shelf(s) in a1L These tracks shall be installed vertically to support the adjustable shelf(s). RtiB RAIL Bottom ed2e ot the side coinpartments shall be trimmed with a bri?ht aluininum extruded rub rai 1. Triin shall be 2.12" high with 1.38" flancres turned outward for rigidity. The rub rails shall not be an inte-Iral part of the body construction, which allows replacement in the event of damacxe. BODY FENDER CRONNINS Stainless steel fender crowns shall be provided around the rear wheel openings. A 1-ubber weltina shall be provided between the body and the crown to seal the seam and restrict moisture from enteriiig. A dielectric ban-ier shall be provided between the fender crown fasteners (screwsj and the fender sheet metal ta prevent con-osion. HA'TDRAILS The handrails shall be 1.25' diameter anodized aluminum extrusion, with a ribbed desi?"n. to provide a positive gripping surface. ?, Chronle plated end stanchions shall support the handrail. Plastic gasl:ets shall be used between end stanchions and any painted surfaces. Drain holes shall be provided ii7 the bottom of all vertically inounted handrails. - Two (2) handrails shall be provided above each side pump panel, Bidder Complies Yes I No Pa¢e 43