2001-096 Resolution - Laserfiche WebLink

Home Browse Search

Specifications Electrical cord or conduit shall be supported within six (6) inches (152 n1m) of any junction boa and at a minimum of even, 24 inches (610 mm) of continuous run. Supports shall be made of nonmetallic materials or corrosion protected metaL All supports shall be of a design that does not cut or abrade the conduit or cable and shall be mechanically fastened to the vehicle. Wirin? Identification A11 line voltage conductors ]ocated in the main panel board shall be individually and pennanently identified. The identification shall reference the wiring schematic or indicate the final termination poin±. When prewiring for future power sources or devices; the unternlinated ends shall be labeled showing function and wire size. Wet Locations All wet location receptacle outlets and inlet devices, inclucting those on hardwired remote power distribution boxes, shall be of the grounding type provided with a wet location cover and installed in accordance with Section 210-7 "Receptacles and Cord Connections" of the NEC. All receptacles located in a wet location shall be not less than 24 inches (610 rmn) from the ground. Receptacles on off-road velucles shall be a minimum of 30 inches (762 mm) from the --round. The face of any wet location receptaele shall be installed in a plane from vertical to not more than 45 degrees off vertical. No receptacle shall be installed in a face up position. Drv Locations All receptacles located in a drv location shall be of tne grounding t_ype. Receptacles shall be not less than 30 inches (762 mm) above the interior floor height. All receptacles sha11 be marked xith the type of line voltage (120-volts or 240-volts) and the cuz7ent rating in amps. If the receptacles are direct cun-ent, or other than single pliase, they shail be so marked. ListinL, A11 receptacles and electrical iniet devices shall be listed to UL, 498, Standard for Safety Attachznent Plugs and Receptacles, or other appropriate performance standards. Receptacles used for direct current volta?es shall be rated for the appropriate sernice. Electrical Svstem Testin? The wiring and associated equipment shall be tested by the apparatus manufacturer or the installer of the line voltage system. The wiring and peimanently connected devices and equipment shall be subjected to a dielectric voltage withstand test of 900-volts for one (1) minute. The test shall be conducted Bidder Complies Yes I No Page 67