Laserfiche WebLink
• <br /> D. Block Insulation: Install foamed in place two component thermal insulation in all ungrouted <br /> cells of masonry in exterior walls. <br /> E. Roofing Insulation: Install roofing insulation in accordance with insulation and roofing <br /> manufacturer printed instructions and recommendations. <br /> F. Safing Insulation: Install safing insulation in accordance with UL design requirements and in <br /> accordance with manufacturer's recommendations. <br /> G. Sprayed Polyurethane Foam: Install in strict accordance with manufacturer's <br /> recommendations. Separate final installation with code approved thermal barrier. <br /> 3.03 ADJUSTMENT AND CLEANING <br /> A. Adequately protect Work from damage resulting from subsequent construction operations. <br /> Replace damaged or soiled Work. <br /> - END OF SECTION - <br /> SECTION 07600 <br /> FLASHING AND SHEET METAL <br /> PART 1 -- GENERAL <br /> 1.01 THE REQUIREMENT <br /> A. Furnish labor,materials, equipment and appliances required for complete execution ofWork <br /> shown on Drawings and specified herein. <br /> 1.02 RELATED WORK SPECIFIED ELSEWHERE <br /> A. Section 04200 - Unit Masonry <br /> B. Section 07510 — Built-up Bituminous Roofing <br /> C. Section 07700— Roof Specialties and Accessories <br /> D. Section 07900 - Joint Fillers, Sealants and Caulking <br /> 1.03 REFERENCES SPECIFICATIONS, CODES AND STANDARDS <br /> A. Without limiting the generality of these specifications Work shall conform to the applicable <br /> requirements of the following documents: <br /> 1. OF-506C Flux, Soldering, Paste, and Liquid <br /> 2. ASTM A176 Stainless and Heat-Resisting Chromium Steel Plate, Sheet and <br /> Strip <br /> 3. ASTM B32 Specifications for Solder Metal <br /> 4. ASTM D1187 Test Method for Asphalt-Base Emulsions for use as Protective <br /> Coatings for Metal <br /> 5. "Architectural SheetMetalManual" by SheetMetal and Air Conditioning Contractors <br /> National Association. <br /> 1.04 SUBMITTALS <br /> A. In accordance with the procedures and requirements set forth in Section 01300 - Submittals, <br /> submit the following: <br /> 1. Manufacturer's literature and installation instructions. <br /> 2. Complete layout and installation Drawings and schedules with clearly indicated <br /> dimensions. <br /> 3. Color samples. <br /> 083105BR <br /> 30048-005: 5/30/2012 07600-2 North Olmsted Phase 2 <br /> 1.05 DELIVERY, STORAGE, AND HANDLING <br /> A. Store materials in a clean dry protected area in such manner to preclude damage by <br /> denting, warping, or other distortion. <br />