Laserfiche WebLink
C. Section 07600 - Flashing and Sheet Metal <br /> D. Section 07900 - Joint Fillers, Sealants and Caulking <br /> 1.03 REFERENCE SPECIFICATIONS, CODES, AND STANDARDS <br /> A. Without limiting the generality of these specifications Work shall conform to the applicable <br /> requirements of the following documents: <br /> 1. TT-P-641 (1) Primer Coating, Zinc Dust -Zinc Oxide (for galvanized surfaces <br /> 2. ASTM A 525 Specification for General Requirements for Steel Sheet, Zinc <br /> Coated (Galvanized) by the Hot-Dip Process. <br /> 3. ASTM A 526 Specification for Steel Sheet, Zinc Coated (Galvanized) by the <br /> Hot-Dip Process, Commercial Quality. <br /> 4. ASTM B 209 Specification for Aluminum and Aluminum-AlloySheet and Plate. <br /> 5. Sheet Metal and Air Conditioning Contractors National Association "Architectural <br /> Sheet Metal Manual" (ASMM). <br /> 6. The Aluminum Association "Specification for AluminumSheetMetalWork in Building <br /> Construction." <br /> 7. American Welding Society (AWS). <br /> 1.04 SUBMITTALS <br /> A. In accordance with the procedures and requirements set forth in Section 01300, Submittals, <br /> submit the following: <br /> 1. Manufacturers literature and installation instructions. <br /> 081511BR <br /> 30048-005: 5/30/2012 07700-2 North Olmsted Phase 2 <br /> 2. Samples, of each material listed. <br /> 1.05 DELIVERY, STORAGE AND HANDLING <br /> A. Deliver all materials in factory packed unopened cartons and crating bearing the <br /> manufacturer's labels. <br /> B. Store materials in clean, dry protected area in such manner to preclude damage of any <br /> nature. <br /> C. Handle all materials with proper care to avoid denting, marring, warping or other distortions <br /> during delivery, storage and handling. <br /> PART 2 -- PRODUCTS <br /> 2.01 MATERIALS <br /> A. General: Provide roof specialties and accessories of design and construction compatible <br /> and approved for use with roofing manufacturer. <br /> B. Fasteners: Provide all fasteners and attachments required to secure item to substrate and <br /> support loads required by applicable Building Code. Use only non-corrosive fasteners which <br /> are compatible with materials being joined. <br /> C. Colors: Colors shall be selected by Owner. <br /> 2.02 ROOF CURBS <br /> A. Material: 18 gauge, G-90 galvanized steel, 12 inches high with mitered and continuous <br /> welded corners and seams, factory installed pressure treated wood nailers, and rigid <br /> fiberglass insulation. <br /> B. Design: Provide roof curb units manufactured to fit manufactured roof panels. Provide <br /> integral water diverter. Design roof curb to support weight of equipment. Coordinate roof <br /> curb unit with roof panel manufacturer to ensure proper fit. Roof curb shall be approved for <br /> use by manufacturer. <br /> C. Accessories: Provide interior liner, flashing, trim and other items required for a complete <br /> installation. <br /> 2.03 COPINGS <br /> A. Material: 0.063 inches aluminum with smooth surfaces. <br /> B. Splice Plate: Aluminum and finished to match coping. Provide six inch wide units at <br />